Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
| blog:20250105 [2025/01/04 22:15] – Tara O'Donnell | blog:20250105 [2025/01/04 22:44] (current) – Tara O'Donnell | ||
|---|---|---|---|
| Line 21: | Line 21: | ||
| =====Log===== | =====Log===== | ||
| + | -when starting up the telescope was very not at zenith, and when checking the control computer shutdown procedure was not followed | ||
| + | |||
| + | -so tracking, drives, motor driver chassis and halt motors where on and out but the telescope would not move | ||
| + | |||
| + | -shut down correctly and restarted but to no avail | ||
| + | |||
| + | -because telescope was at limit no commands were getting to the motors | ||
| + | |||
| + | -set up steppladder and pushed on the telescope while slewing in the southbound direction to get it out of limit | ||
| + | |||
| + | -once out of limit could use hand paddle to get it to zenith and confirmed position in TCS | ||
| + | |||
| + | -tried to open mirror doors but only south opened repeated opening several times on the control computer and tried it manually still stuck so decided to pack it in | ||
| + | - | ||
| + | |||
| =====ToDo===== | =====ToDo===== | ||
| Line 30: | Line 45: | ||
| =====Data===== | =====Data===== | ||
| - | {{tag>[picsarr]}} | + | {{tag> |