blog:20250221

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision		 Previous revision
blog:20250221 [2025/02/21 20:16] – Sarah Spicerblog:20250221 [2025/02/22 02:47] (current) – dsusho1
Line 4: Line 4:
  
 =====Attendance===== =====Attendance=====
-Dimitry, Sarah, Saisri+Dimitry, Sarah, Saisri, Nick, Bhanu
  
 =====Spaces Occupied===== =====Spaces Occupied=====
Line 15: Line 15:
 =====Equipment Used===== =====Equipment Used=====
 ^ Scope ^ Camera ^ Focus ^ ^ Scope ^ Camera ^ Focus ^
-|Main|PICSI2 w/ 178||+|Main|PICSI2 w/ 532MM||
 |Finder|ASI 482|2465| |Finder|ASI 482|2465|
  
Line 30: Line 30:
  
 - Pointing took hours. Started around 1530, attempted to locate Venus and Jupiter but never found either. Managed to point using astrometry at around 1820 and successfully located Venus. - Pointing took hours. Started around 1530, attempted to locate Venus and Jupiter but never found either. Managed to point using astrometry at around 1820 and successfully located Venus.
 +
 +- Mirror door issue persisted after changing the instrument and while shutting down. Eileen's note: Issue was the East door being lapped on top of North. We eventually closed the dome to warm things back up, and about 15 minutes after that, I was trying to hold the limit switches on north and west while opening, to see if that would prevent east getting "bound" by those (stuck) doors before it could open. It did allow us to finally get them unstuck but it's not clear if it was the limit switch trick or just warming up the motors. Might consider installing small heating elements around the motors that can be turned on as needed if thermal state is your issue (this is actually not uncommon at other observatories I know of).
  
 =====ToDo===== =====ToDo=====