startup

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision		 Previous revision
startup [2023/10/24 18:24] – Roy Proutystartup [2023/11/09 16:38] (current) – removed Roy Prouty
Line 1: Line 1:
-**Terms** 
  
-DC - Data Computer 
- 
-CC - Control Computer 
- 
-MDC - Motor Driver Chassis (Front Panel with buttons and switches) 
- 
-Zenith - Straight-Up 
- 
-LHS - left Hand Side 
- 
-RHS - Right Hand Side 
- 
- - In Dome (bring cameras) 
-    - Set thermostat to lowest setting (exhaust fan should turn on) 
-    - Ensure all cameras to be used are connected to power/data (where applicable) 
-    - Ensure instrument rotator is connected  
- 
-- DC & CC Login 
- 
- 
-- DC Open browser and begin blog 
- 
- 
-- DC Load "Blue Iris Admin" (located in Start Menu) & confirm that DFM Scope is at Zenith (or close near-about) 
-    - This will need to be updooted when we add more cameras 
- 
- 
-- DC Open Kinesis (Thor Labs Instrument Rotator) 
- 
-- CC Open "DFMTCS", "TheSky6", & "ASCOM Dome Control" (all located in Start Menu) 
- 
-- MDC Enable "MTR DRIVER CHASSIS", "DRIVES", "TRACK", "AUTO DOME", and unpress "HALT MOTORS" button (big red, top-right) 
- 
-- CC  With 3 & 4, DFMTCS "Status" box should read "SETTING" and then clear 
- 
-- CC Set Tracking Rates (Setting Tracking Rate in DFMTCS) 
- 
-- CC ASCOM Dome Control: Click "Connect" on RHS; then enable checkbox "Slave Dome to Scope" 
- 
-- CC ASCOM Dome Control: Click "Open" and confirm with BlueIris that dome shutters open correctly 
- 
-- CC TheSky6 : "Telescope" > "Link" > "Establish" from top menu 
-    - Verify white crosshairs are in center (i.e., at zenith) 
-    - If they aren't: restart TheSky6 (This likely needs another page or smthn) 
- 
- 
-- CC Navigate to DFMTCS → Telescope → Misc... → Open Mirror Doors (under Switches/Mirror Door tab) 
-    - The MDC Mirror Door switch should always remain in "OPEN" position 
- 
- 
-- DC Navigate to "Outlet Control" in browser bookmarks bar 
-    - The credentials should auto-fill 
-    - "Switch On" outlets for 
- 
- 
-- DC Open two instances of "SharpCap" (located in Start Menu) 
-    - From top menu, select "Cameras" and ensure the appropriate cameras are listed (e.g., ASi294MM Pro") 
- 
- 
-- Likely next step is to move on to Pointing Procedure