wiki:facility:usage:how_to_use:start-up_procedure

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision		 Previous revision
wiki:facility:usage:how_to_use:start-up_procedure [2023/11/13 15:08] – Roy Proutywiki:facility:usage:how_to_use:start-up_procedure [Unknown date] (current) – removed - external edit (Unknown date) 127.0.0.1
Line 1: Line 1:
-====== Start-up Procedure ====== 
- 
-===== Semantics ===== 
- 
-DC - Data Computer\\ 
-CC - Control Computer\\ 
-MDC - Motor Driver Chassis (Front Panel with buttons and switches)\\ 
-Zenith - Straight-Up\\ 
-LHS - left Hand Side\\ 
-RHS - Right Hand Side 
- 
-===== Procedure ===== 
- 
-  - 
- 
-DC & CC - Login 
- 
-  - DC - Open browser and begin blog 
-  - DC - Load "Blue Iris Admin" (located in Start Menu) & confirm that DFM Scope is at Zenith (or close near-about) 
-      - This will need to be updooted when we add more cameras 
-  - CC - Open "DFMTCS", "TheSky6", & "ASCOM Dome Control" (all located in Start Menu) 
-  - MDC - Enable "MTR DRIVER CHASSIS", "DRIVES", "TRACKING", "AUTO DOME", and unpress "HALT MOTORS" button (big red, top-right) 
-  - CC - With 3 & 4, DFMTCS "Status" box should read "SETTING" and then clear 
-  - CC - [[~:..:tracking_autoguiding:set_tracking_rate|Set Tracking Rate]] 
-  - CC - ASCOM Dome Control: Click "Connect" on RHS; then enable checkbox "Slave Dome to Scope" 
-  - CC - ASCOM Dome Control: Click "Open" and confirm with BlueIris that dome shutters open correctly 
-  - CC - TheSky6 : "Telescope" > "Link" > "Establish" from top menu 
-      - Verify white crosshairs are in center (i.e., at zenith) 
-      - If they aren't: restart TheSky6 (This likely needs another page or smthn) 
-  - CC - Navigate to DFMTCS → Telescope → Misc… → Open Mirror Doors (under Switches/Mirror Door tab) 
-      - The MDC Mirror Door switch should always remain in "OPEN" position 
-  - DC - Navigate to "Outlet Control" in browser bookmarks bar 
-      - The credentials should auto-fill 
-      - "Switch On" outlets 1-4 
-  - In Dome 
-      - Set thermostat to lowest setting (exhaust fan should turn on) 
-  - DC - Open two instances of "SharpCap" (located in Start Menu) 
-      - From top menu, select "Cameras" and ensure the appropriate cameras are listed (e.g., "ASi294MM Pro") 
-  - CC - Before moving telescope, Open Mirror Doors via DFMTCS 
-  - Before getting started, you'll likely need to [[~:..:pointing|point the telescope]] 
-