wiki:usage:how_to_use:start_up

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

wiki:usage:how_to_use:start_up [2023/11/09 16:38] – created Roy Proutywiki:usage:how_to_use:start_up [Unknown date] (current) – removed - external edit (Unknown date) 127.0.0.1
Line 1: Line 1:
-**Terms** 
  
-DC: Data Computer 
- 
-CC: Control Computer 
- 
-MDC: Motor Driver Chassis (Front Panel with buttons and switches) 
- 
-Zenith: Straight-Up 
- 
-LHS: left Hand Side 
- 
-RHS: Right Hand Side 
- 
- 
----- 
- 
-   - In Dome (bring cameras) 
-      - Set thermostat to lowest setting (exhaust fan should turn on) 
-      - Ensure all cameras to be used are connected to power/data (where applicable) 
-      - Ensure instrument rotator is connected  
-  - DC & CC Login 
-  - DC Open browser and begin blog 
-  - DC Load "Blue Iris Admin" (located in Start Menu) & confirm that DFM Scope is at Zenith (or close near-about) 
-  - DC Open Kinesis (Thor Labs Instrument Rotator) 
-  - CC Open "DFMTCS", "TheSky6", & "ASCOM Dome Control" (all located in Start Menu) 
-  - MDC Enable "MTR DRIVER CHASSIS", "DRIVES", "TRACK", "AUTO DOME", and unpress "HALT MOTORS" button (big red, top-right) 
-      - With the above, DFMTCS "Status" box should read "SETTING" and then clear 
-  - CC Set Tracking Rates (Setting Tracking Rate in DFMTCS) 
-  - CC ASCOM Dome Control: Click "Connect" on RHS; then enable checkbox "Slave Dome to Scope" 
-  - CC ASCOM Dome Control: Click "Open" and confirm with BlueIris that dome shutters open correctly 
-  - CC TheSky6 : "Telescope" > "Link" > "Establish" from top menu 
-      - Verify white crosshairs are in center (i.e., at zenith) 
-      - If they aren't: restart TheSky6 (This likely needs another page) 
-  - CC Navigate to DFMTCS → Telescope → Misc -> Switches/Mirror Doors tab → Open Mirror Doors  
-      - The MDC Mirror Door switch should always remain in "OPEN" position 
-  - DC Navigate to "Power Controller" in browser bookmarks bar 
-      - The credentials should auto-fill 
-      - "Switch On" all outlets 
-  - DC Open "SharpCap" (located in Start Menu) 
-    - From top menu, select "Cameras" and ensure the appropriate cameras are listed (e.g., ASi294MM Pro") 
-  - Likely next step is to move on to [[Pointing]]